Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
64
Immediate Data Mode 4
Current Mode of Operation is 1
Enter Mode of Operation :
You can now enter the mode of operation that you wish followed by <cr>. The
module will return to the main configuration menu.
TIME TAG MODE
Type “8” (in the configuration main menu) and <cr> to enable or disable the time tag
mode. The module will respond:
Current Time Tag Mode is Disabled
Enable 1
Disable 2
Exit X
Enter Selection:
Type the appropriate number to enable or disable time tag or "X" (for no change)
followed by <cr>. The module will return to the main configuration menu.
CONNECT PORT ID ECHO
Type “9” (in the configuration main menu) and <cr> to enable or disable the connect
port ID echo. The module will respond:
Connect Port ID Echo is................Disabled
Change it? (Y/N) :
Type “Y” to change the current setting or “N” to exit to the main configuration menu.
If Connect Port ID Echo is enabled, the programmed Port ID will be sent to the host
computer whenever a Serial port is selected.
NOTE: Connect Port ID Echo is not functional if the peripheral module is
operating in command mode.
EXIT
Type “X” (in the configuration main menu) and <cr> to exit the configuration mode.
V77 ADM-1 MODULE CONFIGURATION