Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE CONFIGURATION

____________________________________________________________________________

NOTE: If you type "0" from this menu, all completed messages are sent to

the base unit (i.e., the service port or service modem).

The module will respond with:

Enter New Host Port Number (1 - 4):

Type the desired port number followed by <cr>.

NOTE: If a V71 is the designated host module, the host port number is "1"

(default). If the base unit is the designated host module, the host port

number is "1" for the service port or "2" for the service modem.

All completed messages received while operating in immediate reporting mode are

sent to the designated host port.

MESSAGE TERMINATE CHARACTER

Type “6” (in the configuration main menu) and <cr> to change the message terminate

character. The module will respond:

Current Terminate Character is.............0DH

Enter Terminate Character in Hex

or ENTER for no change ....................:

Enter the desired message terminating character in the form of a two-digit

hexadecimal character from 00 Hex to 7F Hex. For example, if you enter "0A" (Line

Feed), the module will respond with:

Current Terminate Character is.............0AH

Enter Terminate Character in Hex

or ENTER for no change ....................:

If the displayed terminate character is satisfactory, type <cr> and the module will

return to the main configuration menu

MODE OF OPERATION

Type “7” (in the configuration main menu) and <cr> to change the mode of operation.

The module will respond:

MODE OF OPERATION

Full Duplex Mode 1

Immediate Message Mode 2

Command Mode 3