Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
62
If the port device name is satisfactory, type <cr> and the will respond with:
Enter Port Number (? = Help, ENTER = Exit) :
Enter the number of any other port you wish to reconfigure. If there are no other
ports, type <cr> and the module will return the main configuration menu.
PORT ID
Type “4” (in the configuration main menu) and <cr> to change the port ID. The
module will respond:
Enter Port Number (? = Help, ENTER = Exit) :
Type the desired port number followed by <cr> or type <cr> without any number to
exit to the main configuration menu. For example, if you type "1" followed by <cr>
for Port 1, the I/O module responds with:
Current Module 3 Port I.D :
Port Port ID
1 01:03,1
Disable Port I.D 1
Use Unit,Module,Port number 2
Use Device Name 3
Select Port I.D (ENTER = no change):
Type "1" to disable the Port ID feature, "2" to send the selected port's Unit
Number:Module Number,Port Number as the Port ID, or "3" to send the selected
port's device name as the Port ID.
DESIGNATE HOST PORT LOCATION
Type “5” (in the configuration main menu) and <cr> to designate the host port
location. The module will respond:
Current Host Designation is Module........1:1,1
Enter New Host Unit Number (1-30):
Type the desired unit number followed by <cr>. The module will respond with:
Enter New Host Module Number (1 to 16):
Type the desired module number followed by <cr>.