Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
61
Save Changes Permanently ? (Y/N) :
If you type "Y", the new configuration for the selected port is stored permanently in
non-volatile memory and the module will subsequently power up at the new
configuration. If you type "N", the new configuration is stored in RAM and lost once
power is removed from the unit. After you type the desired response to the save
changes prompt, the module will respond with:
Enter Serial Port Number (? = Help, ENTER = Exit) :
Enter the number of any other port you wish to reconfigure. If there are no other
ports, type <cr> and the module will return to the main configuration menu.
CHANGE PORT DEVICE NAME
Type “3” (in the configuration main menu) and <cr> to change the Port Device Name.
The module will respond:
Enter Port Number (? = Help, ENTER = Exit) :
Type the port number that you wish to reconfigure followed by <cr>. If you wish to
review the device name status for all ports of the module, type "?". For example, if
you enter "4", the module will respond with:
Current Module 1 Serial Port Configuration :
Xon / XoffPort Device
Name
Baud
Rate
Word
Size
Stop
Bits
Parity
Xmit Recv
4 Device D 115.2K 8 1 None Off Off
Enter Port Device Name (Max 16 Characters)
Or ENTER for no change…………………..:
Enter the desired port device name up to 16 characters. For example, if you enter
"Port 4", the module will respond with:
Current Module 1 Serial Port Configuration :
Xon / XoffPort Device
Name
Baud
Rate
Word
Size
Stop
Bits
Parity
Xmit Recv
4 PORT 4 115.2K 8 1 None Off Off
Enter Port Device Name (Max 16 Characters)
Or ENTER for no change…………………..: