Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
60
Enter Request :
Send "A" for 115.2K baud rate, and the module will respond with the reconfigured
status of the port, the option menu, and the prompt:
Current Module 1 Serial Port Configuration :
Xon / XoffPort Device
Name
Rate Word
Size
Stop
Bits
Parity
Xmit Recv
4 Device D 115.2K 8 1 None Off Off
Exit/Save 1 Set Stop Bits 4
Set Baud Rate 2 Set Parity 5
Set Word Size 3 Set Xon/Xoff 6
Enter Request:
You can now select other options from the menu to reconfigure Port 4. For example,
to enable Xon/Xoff handshaking in the receive data direction only, send "6" (Set
Xon/Xoff Xmit) in response to the prompt. The module will respond with:
Output Flow Control (Xmit) - Xon/Xoff is ( OFF )
Stop/Restart Output Upon Receiving of Xoff/Xon ? (Y/N) :
Enter "Y" to enable XON/XOFF on transmit or "N" to disable XON/XOFF on
transmit. Following our example, enter "N" and the module will respond with:
Input Flow Control (Recv) - Xon/Xoff is ( Off )
Xoff/Xon sent based on Buffer - Full/Empty condition ? (Y/N) :
Enter "Y" to enable XON/XOFF on receive or "N" to disable XON/XOFF on receive.
Following our example, enter "Y" and the module will respond with the reconfigured
status for Port 4 as follows:
Current Module 1 Serial Port Configuration
Xon / XoffPort Device
Name
Baud
Rate
Word
Size
Stop
Bits
Parity
Xmit Recv
4 Device D 9600 8 1 None Off On
Exit/Save 1 Set Stop Bits 4
Set Baud Rate 2 Set Parity 5
Set Word Size 3 Set Xon/Xoff 6
Enter Request:
If there are no other changes for this port, send "1" (Exit/Save) and the module will
respond with: