Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE CONFIGURATION

____________________________________________________________________________

EXIT

Type “X” (in the status and diagnostics menu) and <cr> exit the configuration menu.

The module will respond:

Unit MUST BE RESET for configuration

changes to take effect.

V74/V75/V87 SERIAL I/O MODULE CONFIGURATION

Configuration changes for the V74/V75/V87 modules are made through any host

module, the service port, or the front panel. To access the configuration mode of a 4-

port serial module from any host module, use the procedures on page 44.

MAIN MENU CONFIGURATION

With $CONFIG input the serial module installed as Module X will respond with an

identification block and a menu of the available configuration options similar to the

following:

Model V73/V74/V76 etc. High Speed Serial 4C

Revision F.X.XX

Unit: 1, Module: 2

Status 1

Serial Port Configuration 2

Port Device Name 3

Port I.D 4

Designate Host Port location 5

Message Terminate Character 6

Mode of Operation 7

Time Tag Mode 8

Connect Port ID Echo 9

Exit X

Enter Request :

NOTE: Menu selection is case sensitive. It is recommended that your

keyboard be in the CAPS LOCK position.

IMPORTANT: If you change the Message Terminate Character or Mode

of Operation, when you type "X" from the above menu (Exit), the module

will respond with:

Mode Of Operation or Terminate Character has been Changed!

Press Any Key To Reset This Unit...