Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE CONFIGURATION

____________________________________________________________________________

Type “3” (in the configuration main menu) and <cr> to change gateway. The module

will respond:

Enter Gateway address in dotted decimal form:

Enter the desired Gateway or router address as a series of four numbers separated by

periods (e.g., 197.3.14.1) followed by <cr>.

IMPORTANT: After programming the Gateway address, the M-Series unit

must be reset for the new information to take effect.

SELECT CODE

Type “4” (in the configuration main menu) and <cr> to change the select code. The

module will respond:

Enter Select Code (8 chars max):

Type the desired port select code followed by <cr>. The V72 saves the new port select

code permanently in the non-volatile memory and returns to the main configuration

menu.

NOTE: The select code is case sensitive. You cannot program the port select

code to be $BT from the service port or service modem.

NOTE: It is not necessary to reset the unit for this option to take effect.

PASSWORD

Type “5” (in the configuration main menu) and <cr> to change the password. The

module will respond:

Current password: BTA

Enter Password (8 chars max):

Type the desired password up to eight ASCII characters. Press <cr> to return to the

main configuration menu.

IMPORTANT: Record your password and keep it in a secure place. If a

password is lost or forgotten, you must contact a BayTech applications

engineer and provide authenticated authorization for the password retrieval

procedure.

NOTE: The password is case sensitive. Any non-alphanumeric character

including <BACKSPACE> and <DELETE> or a password greater than eight

characters is interpreted as an input error and you will be prompted to enter the

password again.

Terminate the password entry by typing the <cr> key. The V72 will respond with: