Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE CONFIGURATION

____________________________________________________________________________

EXIT CONFIGURATION

Type “X” and <cr> to exit the configuration menu. The V71 will respond:

Change your devices to match new configuration

This reminds you to change the host computer to match any serial port configuration

changes. You should change the appropriate host computer parameters to match the

new serial port configuration of the V71 at this point.

CAUTION: Failure to change the host computer serial parameters to match

the new serial parameters of the V71 after exiting configuration mode locks

you out of all V71 functions. If this happens and you forget what changes

were made, you can review the V71 configuration status and make any

changes from the service port or the service modem of the M Series base

unit.

IMPORTANT: After exiting the V71 configuration mode and making any

necessary changes to the host computer, you must send the port select code

immediately followed by <cr> (e.g., $BT<cr>) to resume normal

communications between the V71 and the relevant I/O modules. Failure to

do so prevents the V71 from receiving any data from the I/O modules.

V72TP HOST MODULE CONFIGURATION

MAIN CONFIGURATION MENU

Configuration changes for the V72/V72TP host modules are made through the service

port, or the service modem. To access the configuration mode of of the V72/V72TP

module use the procedures on page 45.

With $CONFIG input the V72/V72TP host module installed as Module X will

respond with an identification block and a menu of the available configuration options

similar to the following:

M-Series V72-TP DAC Host

Unit : 1 Module: 1