Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
48
Enter Request :
NOTE: This menu shows the V71 installed as Module 1. A line showing
the amount of memory is displayed as the third line in the header if an M03
memory module is installed.
NOTE: Menu selections are case sensitive. It is recommended your
keyboard be in the CAPS LOCK position.
STATUS
Type “1” and <cr> to review the status of the V71 module. The V71 will respond:
Xon / XoffPort Baud
Rate
Word
Size
Stop
Bits
Parity
Xmit Recv
Line
Interface
1 9600 8 1 None Off Off EIA-232
Port Select Code is:$BT
Unit Number is : 1
Strike any key to continue
Copyright (c) Bay Technical Associates, 199X
DAC V71 Rev. X.XX
This Module is 1
1) Status
2) Port Select Code
3) Serial Port Configuration
X) Exit Configuration
Enter Request :
You can now make whatever changes are necessary by responding to the above menu.
The "X" (Exit Configuration) will return you to the operations mode.
PORT SELECT CODE
Type “2” and <cr> to enter the port select code menu. The V71 will respond: