Owner`s manual
M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
47
SET UNIT NUMBER
Type "3" from the menu above to receive the following prompt:
Enter unit (1-30):
Type the desired Unit Number.
BASE UNIT DYNAMIC CONFIGURATION COMMANDS
You can configure the date and time for the base unit from a host communications
module by sending the "ST" (Set Time) dynamic configuration command. The host
communications module must first select base unit prior to sending the "ST"
command. This is done by sending the port select code, "0", and <cr>. The format of
the "ST" command is as follows:
ST HH:MM:SS,MM/DD/YY<cr>
HH is the desired hour, the first MM is the desired minute, SS is the desired second,
the second MM is the desired month, DD is the desired day, YY is the desired year.
For example; 11:59:59 on December 31, 1999 equates to:
$BT0<cr>ST 11:59:59,12/31/99<cr>
V71 HOST MODULE CONFIGURATION
V71 MAIN MENU CONFIGURATION
Configuration changes for the V71 host module are made through one of the
configuration ports. To access the configuration mode for the V71, use one of the
procedures on page 44.
With $CONFIG input the V71 host module installed as Module X will respond with
an identification block and a menu of the available configuration options similar to
the following:
Copyright (c) Bay Technical Associates, 199X
DAC V71 Rev. X.XX
This Module is 1
1) Status
2) Port Select Code
3) Serial Port Configuration
X) Exit Configuration