Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE CONFIGURATION

____________________________________________________________________________

NOTE: Substitute module number (1-16) for base unit number (0) to

configure other modules.

3. Access configuration mode by sending $CONFIG<cr>. No

characters should be typed between $BT0<cr> and $CONFIG<cr>.

(Use $BAYTECH0<cr> on M4 and M8 DAC.)

Once you access configuration mode (for the base unit) from a host communications

module, the service port, or the service modem, the following menu will appear on

the terminal screen:

Control Board System Menu

Bay Technical Associates

Unit Number 001

Set Date 1

Set Time 2

Set Unit Number 3

Exit System Menu X

Enter Request:

Enter the desired selection. The "X" selection (Exit System Menu) will return you to

operations mode. Once you exit configuration mode, you should disconnect by

sending $BT<cr>. (Use $BAYTECH<cr> when using M4 and M8 DAC).

NOTE: Other configuration screens will appear based on the module

number accessed. Refer to the appropriate module type for the

proper configuration of those modules.

SET DATE

Type "1" from the menu above to receive the following prompt:

Enter date <MM/DD/YY>:

Type the desired date. For example, to enter December 31, 1999, type 12/31/99.

SET TIME

Type "2" from the menu above to receive the following prompt:

Enter time <HH:MM:SS>:

Type the desired time. For example, to enter 11:59:59, type 11:59:59.