Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE CONFIGURATION

____________________________________________________________________________

BASE UNIT AND MODULE CONFIGURATION

BASE UNIT CONFIGURATION

The base unit can be configured from the service port, the service modem, or a host

control module.

NOTE: Once the date has been programmed, the base unit will

automatically adjust for months having 28, 29, 30, or 31 days for all years up

to 2087. The base unit also tracks the correct day of the week automatically.

HOST MODULE, SERVICE PORT, AND SERVICE MODEM

CONFIGURATION (CONFIGURATION PORTS)

To access configuration mode of the base unit from one of the configuration ports,

use one of the following procedures.

NOTE: The configuration ports will not respond to commands for

approximately 15 seconds after the unit is powered up or reset.

HOST MODULE ACCESS

1. Connect a terminal to the host module and access the base unit

configuration menu using either the menu mode:

a) Select configuration mode by typing “C” followed by <cr>

at the main prompt ;

b) and type the number of of the base unit (varies with

number of module slots avaialable), followed by <cr>.

or the dynamic configuration mode.

a) Connect to the base unit by sending the port select code

($BT - default), 0, and <cr>.

NOTE: Substitute module number (1-16) for base unit number (0) to

configure other modules.

b) Access configuration mode by sending $CONFIG<cr>.

For example, if using the default port select code, send

$BT0<cr>$CONFIG<cr> to enter into configuration mode