Owner`s manual

M SERIES DAC

INSTALLATION

____________________________________________________________________________

INSTALLATION

UNPACKING

Compare the unit and serial number of the equipment you received to the packing slip

located on the outside of the box. Log this information on the sheet on page 186.

Inspect equipment carefully for damage that may have occurred in shipment. If there

is damage to the equipment or if materials are missing, contact BayTech technical

support at 228-467-8231 or call toll free inside the United States at 800-523-2702. At

a minimum, you should receive the following:

a.  The M Series unit.

b.  This manual with any applicable addendum’s.

c.  Power Supply.

d.  1 ea. DE-9 (9 pin) PC com port adapter -- 9FRJ45PC-1.

e.  1 ea. RJ-45 cross over cable -- RJ08X007.

f.  1 ea. RJ-11 telco cable -- RJ04X007 (RPC-2 MD01 &

RPC-2 RDR).

g.  1 ea. external modem adapter -- 25MRJ45MD-8 (RPC-2 RDR).

NOTE: Keep the shipping container and packing material in the event

future shipment is required.

PREPARING THE INSTALLATION SITE

The installation area should be clean and free of extreme temperatures and humidity.

Allow sufficient space behind the M Series unit for cabling and receptacle

connections.

POWER

CAUTION: This unit is intended for indoor use only. Do not install near

water or expose this unit to moisture. To prevent heat buildup, do not coil

the power cord when in use. Do not use extension cords. Do not attempt to

make any internal changes to the power source. Do not attempt to modify

any portion or component of an RPC Series Unit unless specifically directed

to. BayTech must perform any internal operations.