Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE OPERATION
____________________________________________________________________________
182
Configure ............................... C
Manual Mode ............................. M
Exit......................................X
Unit Reset .............................. R
Logout .................................. T
Enter Request: R
The M-Series DAC unit has been reset.
Important: The Unit Reset command will terminate communications
with connected equipment to the M-Series DAC.
You must re-establish communications with the M-Series DAC system
after the unit has been reset.
The Menu is invoked by sending the Attention Character(default ;;;;;)
to the V93A host module five times. The V93A will respond with a
menu similar to the following, if two Serial I/O modules are installed.
LOGOUT
By responding to the Enter Request: message in the V93A Main Menu
with “T” (Logout), you will take you out of menu mode If you have a
modem connection it will terminate that connection. The V93A host
module will respond with a message similar to the following:
Device A (2,1).................... 1
Device B (2,2).................... 2
Device C (2,3).................... 3
Device D (2,4).................... 4
Device A (3,1).................... 5
Device B (3,2).................... 6
Device C (3,3).................... 7
Device D (3,4).................... 8
Configure ............................... C
Manual Mode...... ....................... M
Exit......................................X
Unit Reset .............................. R
Logout .................................. T
Enter Request: