Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE OPERATION
____________________________________________________________________________
181
Enter Port number (<CR> for none): 3
By entering “2” at the Enter Module number and entering “3” at the
Enter Port number, the user has selected module number 2 and port
number 3. Verify the connection by insuring that the red LED of Port
3, Module 2 on the front panel of the M-Series DAC base unit has been
selected.
EXIT
By responding to the Enter Request: message in the V93A Status &
Diagnostics Menu with “X” (Exit), you will exit the V93A Status &
Diagnostics Menu. The V93A host module will respond with a menu that
is similar to the following:
> X
UNIT RESET
Users can instruct the M-Series DAC with the V93A module, to “reset”
by using the Menu Selection Method to reset the unit. The Unit Reset
command does not affect any saved configuration parameters that have
been changed from the default values.
By responding to the Enter Request: message at the end of the menu with
“R”(Unit Reset), you will reset the M-Series unit.
Device A (2,1).................... 1
Device B (2,2).................... 2
Device C (2,3).................... 3
Device D (2,4).................... 4
Device A (3,1).................... 5
Device B (3,2).................... 6
Device C (3,3).................... 7
Device D (3,4).................... 8