Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE OPERATION
____________________________________________________________________________
180
Configure - Allows users enter into the configuration mode for any
installed modules or for the base unit. See Section 6
CONFIGURATION for details to configure the unit.
MANUAL MODE
Manual Mode allows users to manually select a module and/or port. The
“Manual Mode” selection for the V93A menu is used to make a module
level connection which is used for sending commands to the module.
The “Manual Mode” is used to make a connection to a module such as
the Control Relay Module, A-to-D Module, Event Counter Module,
main board, etc. Use the “Manual Mode” for module connections other
than a Serial I/O module unless you want to operate a Serial I/O module
in the Command Mode of operation. The “Manual Mode” selection
should not be used for configuration.
By responding to the Enter Request: message at the end of the V93A
menu with “M” you receive a response similar to the following:
Device A (2,1).................... 1
Device B (2,2).................... 2
Device C (2,3).................... 3
Device D (2,4).................... 4
Device A (3,1).................... 5
Device B (3,2).................... 6
Device C (3,3).................... 7
Device D (3,4).................... 8
Configure ............................... C
Manual Mode ............................. M
Exit......................................X
Unit Reset .............................. R
Logout .................................. T
Enter Request: M
Enter Module number: 2