Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE OPERATION

____________________________________________________________________________

179

commands are typically used to request stored data received from an

I/O module. Data commands are also used to instruct certain I/O

modules to perform a specific task (e.g., energize or de-energize a

relay).

The configuration menu is invoked by selecting configure(C) from the

port selection menu. The supported configuration and data commands

for a specific I/O module are described in the documentation for that

module.

PORT SELECTION MENU

To activate the port selection menu, type 5 or more ;;;;; (default) in a

row and a menu similar to the following will appear.

. M-Series V93A DAC Host

Unit 1 Module 2

Bay Technical Associates

Device A (2,1)............1

Device B (2,2)............2

Device C (2,3)............3

Device D (2,4)............4

Configure.........................C

Manual Mode.......................M

Exit..............................X

Unit Reset........................R

Logout............................T

Enter Request :

The device names in the menu correspond to the device names assigned

to the serial ports installed in the unit. To select a particular device simply

enter the number of the device then hit return. Refer to section 16.4 of

the M-Series DAC owners manual for configuration of device names.

The other items in the menu provide various functions described below: