Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE OPERATION

____________________________________________________________________________

178

communication software packages such as PROCOMM PLUS(R) by

Data Storm Technologies, also provide terminal emulation capabilities

and allow for communications with the V93A.

c. If configuring the V93A from the EIA-232 port, configure the

host terminal’s serial parameters to match those of the V93A. From the

factory, the V93A is set at 9600 baud, 8 data bits, 1 stop bit no parity and

XON/XOFF disabled.

Once the V93A has been connected to the phone line and configured

for the desired parameters, a remote host computer can make a

connection to the V93A modem over a dial line and perform data

acquisition and control functions with the various M Series I/O

modules. The V93A will send a message similar the following when a

remote host computer establishes a connection:

M-Series V93A DAC Host

Unit 2 Module 1

Bay Technical Associates

To login, enter password

You will be prompted to type in the desired password followed by

<ENTER> when a connection to the V93A modem is first made. You

are given three tries to type in the correct password before the modem

hangs up. Type the appropriate password (Default is BTA). The V93A

will respond with:

Port Select Code: $BT

Attnetion Character: ;

Among the functions you can perform are data commands/port

selection and configuration. Configuration commands are used to

program the features of the various I/O modules and the data