Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE OPERATION
____________________________________________________________________________
177
V78 Relay Module
Note: This module must be programmed
to operate in command mode.
1
2
.
.
8
1 = Energized
0 = De-Energized
V79 Switch Closure Module
Note: This module must be programmed
to operate in command mode.
1
2
.
.
16
1 = closed (no resistance)
0 = open (max resistance)
V80 Isolated Voltage Module
Note: This module must be programmed
to operate in command mode.
1
2
.
.
16
1 = voltage detected
0 = no voltage detected
V84 A-to-D/Relay/Switch/Isolated
Voltage Input Module
Note: A-to-D channels must be
programmed to operate in immediate
sampling mode and command reporting
mode.
1 (A-to-D)
2 (A-to-D)
.
.
6 (A-to-D)
7 (Switch/Voltage Input)
.
.
12(Switch/Volatage Input)
13 (Relay)
14 (Relay)
15 (Relay)
16 (Relay)
A-to-D Channels: N/A
Switch Closure Channels:
1 = closed (no resistance)
0 = open (max resistance)
Isolated Voltage Channels:
1 = voltage detected
0 = no voltage detected
Relay Channels:
1 = Energized
0 = De-Energized
V93 OPERATION
a. You are ready to perform commands when a terminal or PC is
communicating with:
(1) the V93A's EIA-232 port.
(2) a remote modem is communicating with the V93A’s
modem.
b. If you are using a PC, you can communicate with the V93A by
using a terminal emulation program or by using a software
communications program that emulates a terminal. BayTech supplies an
utility diskette which includes TERM.EXE, a terminal emulation
program, to put your PC into terminal emulation mode. Popular