Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE OPERATION
____________________________________________________________________________
165
1:15,1 1 11/18/93
09:12:22<cr><lf>
1:15,2 1 11/18/93
09:12:22<cr><lf>
UNIT
MODULE
CHANNEL
CHANNEL STATUS
DATE
TIME
The following examples show the messages received using data commands where the
PDI is installed in Unit 1 Module 15 with time tagging enabled. If you select the
module and issue the RD1<cr> command (Report Event Duration for Channel 1), the
module will respond with a single message showing the Event Duration for Channel 1
similar to the following:
1:15,1 1320 11/18/93 09:12:22
where 1:15,1 represents Unit 1/Module 15/Channel 1, 1320 indicates the event
duration is 1320 milliseconds, and 11/18/93 09:12:22 is the time tag.
If you issue the RC1<cr> command (Report Event Counter for Channel 1), the
module will respond with a message showing the Event Counter similar to the
following:
1:15,1 823 11/18/93 09:12:22
where 1:15,1 represents Unit 1/Module 15/Channel 1, 823 indicates the number of
recorded events is 823 times, and 11/18/93 09:12:22 is the time tag.
If you issue the RS1<cr> command (Report Single Buffered Event for Channel 1),
the module will respond with a message showing the input status for Channel 1
similar to the following:
1:15,1 1 11/18/93 09:12:22
where 1:15,1 represents Unit 1/Module 15/Channel 1, 1 indicates the first buffered
sample for Channel 1 is closed (V79 PDI-1) or has voltage applied (V80 PDI-2), and
11/18/93 09:12:22 is the time tag.
If you issue the RL1<cr> command (Report Event Latch Data for Channel 1), the
module will respond with a message showing the state of the input that started the