Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE OPERATION
____________________________________________________________________________
162
RCn<cr>
where n = Channel# (1 to 16 or 0 for all).
REPORT EVENT DURATION COMMAND
The Report Event Duration (RD) command instructs the PDI to report how long the
most recent recorded event for the selected channel(s) lasted. The Report Event
Duration command has the following format:
RDn<cr>
where n = Channel# (1 to 16 or 0 for all).
REPORT EVENT LATCH DATA COMMAND
The Report Event Latch Data (RL) command instructs the PDI to report the active
state of the initial event and the time the initial event occurred (if time tagging is
enabled). This command does not reset the latch buffer. The Report Event Latch
Data has the following format:
RLn<cr>
where n = Channel# (1 to 16 or 0 for all).
REPORT EVENT COUNTER AND RESET COMMAND
The Report Event Counter and Reset (RO) command instructs the PDI to report how
many times an event has occurred for one or more channels and then reset the event
counter to zero. The Report Event Counter and Reset command has the following
format:
ROn<cr>
where n = Channel# (1 to 16 or 0 for all).
REPORT EVENT LATCH DATA AND RESET COMMAND
The Report Event Latch Data and Reset (RR) command instructs the PDI to report the
active state of the initial event, the time the initial event occurred (if time tagging is
enabled), and then reset the latch buffer. The Report Event Latch Data and Reset
command has the following format: