Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE OPERATION
____________________________________________________________________________
161
The Clear Event Buffer (CB) command is used to clear all stored event samples from
the buffer of the selected channel(s). The Clear Event Buffer command has the
following format:
CBn<cr>
where n = Channel# (1 to 16 or 0 for all).
CLEAR EVENT COUNTER COMMAND
The Clear Event Counter (CC) command is used to reset the event counter for one or
more channels to zero without reading the value of the event counter. The Clear Event
Counter command has the following format:
CCn<cr>
Where n = Channel# (1 to 16 or 0 for all).
CLEAR EVENT LATCH DATA
The Clear Event Counter (CR) command is used to clear the event latch buffer. The
Clear Event Counter command has the following format:
CRn<cr>
where n = Channel# (1 to 16 or 0 for all).
REPORT ALL BUFFERED EVENTS COMMAND
The Report All Buffered Events (RA) command instructs the PDI to report all event
samples currently stored in the buffer of the selected channel(s). The Report All
Buffered Events command has the following format:
RAn<cr>
where n = Channel# (1 to 16 or 0 for all).
REPORT EVENT COUNTER COMMAND
The Report Event Counter (RC) command instructs the PDI to report how many times
an event has occurred for one or more channels since the last time a counter reset
command was issued. This command does not reset the event counter. The Report
Event Counter command has the following format: