Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE OPERATION
____________________________________________________________________________
154
SA1,2,4-8<cr> Take a single sample for Ports 1, 3, 4, 5, 6, 7, and 8
3. After you have sent the desired data commands to the V78 CRM-1
module, you may disconnect by sending $BT<cr>. You may
disconnect from the V78 CRM-1 and select a different module or
the base unit by sending $BTn<cr.
IMPORTANT: If the V78 CRM-1 is operating in self reporting mode (i.e.,
Immediate or Schedule Reporting Method) and a host computer/controller
issues a data command, the host system must disconnect by sending the Port
Select Code and <cr> before the V78 CRM-1 will resume sending data
messages to the designated host module.
CLEAR BUFFER COMMAND
The Clear Buffer (CB) command is used to clear stored data messages from the buffer
of the selected relay(s). The Clear Buffer command has the following format:
CBn<cr>
where n = Relay# (1 to 8 or 0 for all).
REPORT ALL BUFFERED DATA MESSAGES COMMAND
The Report All Buffered Data Messages (RA) command instructs the V78 CRM-1 to
report all data messages currently stored in the buffer of the selected relay(s). The
Report All Buffered Data Messages command has the following format:
RAn<cr>
where n = Relay# (1 to 8 or 0 for all).
REPORT A SINGLE BUFFERED DATA MESSAGE COMMAND
The Report A Single Buffered Data Message (RS) command instructs the V78 CRM-
1 to report the first data message stored in the buffer of the selected relay(s). The
Report A Single Buffer Sample command has the following format:
RSn<cr>
where n = Relay# (1 to 8 or 0 for all).
SAMPLE COMMAND