Owner`s manual
M SERIES DAC
BASE UNIT AND MODULE OPERATION
____________________________________________________________________________
127
V72 MESSAGES
MESSAGE DESCRIPTION
Module "n" not installed Issued when a user tries to connect to a peripheral
module or port that was not reported as installed to the
V72. Verify that correct module number was entered.
Check module operation on power-up to verify normal
initialization.
Module "n" not responding Issued when a module was reported as installed, but
failed to respond within 1 second to a connection
request from the V72. Repeated occurrences of this
message indicate a possible problem with the module.
Check module operation on power-up to verify normal
initialization.
Module "n" busy Issued when a connection request is denied by a
module. A connection is typically denied when a
module is already supporting a connection to another
user.
Module "n", port "p" busy Issued when a port connection request is denied by a
module. A connection is typically denied when a port
on the module is already supporting a connection to
another user.
Login successful Issued when a user completes the login sequence
successfully. Upon the receipt of this message, the
user has full access to the DAC and may issue any
valid V72 command.
Login failed Issued when user enters erroneous password.
Password is case sensitive and will not tolerate any
backspaces or character deletes.
Immediate Mode in use Issued when a user tries to enter immediate receive
mode (by entering "$BTI<cr>") and another user is
already using the resource. Immediate receive mode
may only be used by one user at a time.
Command/Configuration
Mode in use
Issued when a user tries to connect to a module (not a
port) for command mode or configuration purposes (by
entering "$BTn<cr>") and another user is already using
the resource. Command/Configuration mode may only
be used by one user at a time. This particular message
indicates the current user is a network client.
Command/Configuration
Mode in use by Service
Issued when a user tries to connect to a module and the
module is in use by a user connected to the service