Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE OPERATION

____________________________________________________________________________

125

Device C (2,3) 3

Device D (2,4) 4

Device A (3,1) 5

Device B (3,20) 6

Device C (3,3) 7

Device D (3,4) 8

Immediate Data Collection I

Configure C

Manual Connection M

Unit Reset R

Module Status S

Logout T

ASCII STRING COMMAND METHOD

Serial I/O module ports(V74/V75) can also be selected by sending an ASCII character

string to the V72 host module that consists of the Port Select Code (default is $BT), the

desired Serial I/O module number (2 to 3 for M3 DAC), (2 to 6 for M6 DAC), (2 to 9 for

M9 DAC), and (2 to 16 for the M16 DAC), the desired Serial I/O module port number (1

to 4), and <cr>.

For example, to select Port 1 of a V74 module installed as Module 2 using the default

Port Select Code, send $BT2,1<cr>.

To disconnect, either select another V72 module or send the disconnect sequence. The

disconnect sequence consists of the Port Select Code followed by <cr> (e.g., $BT<cr>).

Once you disconnect, you can logout by typing LOGOUT<cr>.

NOTE: These commands are illustrated using the default port select code

($BT).