Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE OPERATION
____________________________________________________________________________
124
By responding with “2” to the “terminate a session” message, the V72 will respond
with a menu that is similar to the following:
Enter number of connection to terminate, <CR>: 2
Connection being terminated.
Active Users:
Address/Port Internal TX/RX Net Data Flo TX/RX Bus Data Flo
TX/RX
1) *200.4.3.10 none/none ok/ok no/ok
2) -200.4.3.10 2,3/2,3 ok/ok ok/ok
The (-) before the address located at Active User number 2 indicates that the session
to Active User 2 will be terminated.
V72 Status & Diagnostics Menu.
System 1
Internal Communications 2
Network Interface 3
Logged Users 4
Exit X
By responding with “X” to the “Exit” message, the user will exit from the V72 Status
and Diagnostics Menu
EXIT
By responding to the Enter Request: message in the V72 Status & Diagnostics Menu
with “X” (Exit), you will exit the V72 Status & Diagnostics Menu. The V72 host
module will respond with the following:
> X
LOGOUT
By responding to the Enter Request: message in the V72 Main Menu with “T” (Logout),
you will terminate your TELNET connection. The V72 host module will respond with a
message similar to the following:
Device A (2,1) 1
Device B (2,2) 2