Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE OPERATION
____________________________________________________________________________
120
By entering “2” at the Enter Module number and entering “3” at the Enter Port
number, the user has selected module number 2 and port number 3. Verify the
connection by insuring that the red LED of Port 3, Module 2 on the front panel of the
M-Series DAC base unit has been selected.
UNIT RESET
Users can instruct the M-Series DAC with the V72 Ethernet module, to “reset” by using
the Menu Selection Method to reset the unit. Only a user connected to the host module
can issue the reset command. Users can also instruct the M-Series DAC to reset by
sending the ASCII string “$BTRESET” from the service port. The Unit Reset and
$BTRESET commands do not affect any saved configuration parameters that have been
changed from the default values.
IMPORTANT: The Unit Reset command will terminate communications
with connected equipment to the M-Series DAC.
You must re-establish communications with the M-Series DAC system after the unit has
been reset. The Unit Reset menu selection is found in the V72 Module Menu. This
Menu is invoked by sending the Attention Character(default ;;;;;) to the V72 host module
five times. The V72 will respond with a menu similar to the following, if two Serial I/O
modules are installed.
By responding to the Enter Request: message at the end of the menu with “R”(Unit
Reset), you will reset the M-Series unit.
Device A (2,1) 1
Device B (2,2) 2
Device C (2,3) 3
Device D (2,4) 4
Device A (3,1) 5
Device B (3,2) 6
Device C (3,3) 7
Device D (3,4) 8
Immediate Data Collection I
Configure C
Manual Connection M
Unit Reset R
Module Status S
Logout T
Enter Request: R
The M-Series DAC unit has been reset.