Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE OPERATION

____________________________________________________________________________

118

Model 74/75 High Speed Serial 4C-232

Revision F.2.13

Unit: 1, Module: 2

Status..................................1

Serial Port Configuration...............2

Port Device Name........................3

Port I.D................................4

Designate Host Port location............5

Message Terminate Character.............6

Mode of Operation.......................7

Time Tag Mode...........................8

Connect Port ID Echo ...................9

Exit....................................X

NOTE: For detailed configuration information see the M-Series DAC

Owner’s Manual Number U140E111-02(Section 16) or other manuals

corresponding to the specific modules installed in your M-Series DAC base

unit.

IMPORTANT: There should be no active connections while configuring the

unit. Reset the M-Series DAC base unit after configuration

NOTE: Users will see the following “CX” message when another session

hosted by the V72 is configuring a module.

MAIN BOARD CONFIGURATION

By responding to the Enter Request: message at the end of the configuration menu with

“3” you receive the “Control Board System Menu” for M-Series DAC Main Board that

looks similar to the following:

Enter Request: 3

Control Board System Menu

Bay Technical Associates

Revision 0.33 C718

Unit Number 001

Set Date 1

Set Time 2