Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE OPERATION
____________________________________________________________________________
117
<Module 2, Port 1 is use by other host.>
IMMEDIATE DATA COLLECTION
By responding to the Enter Request: message at the end of the V72 menu with “I”
users can receive immediate mode data. When “Immediate Data Collection” is
selected, the user receives messages or data from modules configured to operate in
immediate message mode or immediate data mode. Messages are sent automatically
to the designated host computer, when it is received by any port on the peripheral
communications module.
NOTE: Users will see the following “CX” message when another session
hosted by the V72 is in the immediate data collection mode.
<Immediate Data Collection ...........CX. I>
CONFIGURATION
MODULE CONFIGURATION
Configuration changes to the M-Series DAC with a V72 Ethernet module installed can
be made through the V72 host module. The configuration changes can be made for all
the modules installed in the M-Series DAC, except the V72(See Section 8 for V72
Configuration) or a M03 Memory Module. The V72 will respond with a menu
prompting you to enter the desired module number or main board. By responding to
“C” to change the configuration of a M3 DAC with a V72 installed in Module 1 and
two other modules, you will see a menu similar to the following:
Enter Request: C
Configuration
Module 2 1
Module 3 2
Main Board 3
Exit X
Enter Request: 1
By responding to the Enter Request: message at the end of the configuration menu
with “1” you receive the configuration menu for Module 2 that looks similar to the
following:
Enter Request: 1