Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE OPERATION

____________________________________________________________________________

116

To login, enter password. (default is BTA in capital letters)

Attention Character: ;

Device A (2,1 1

Device B (2,2 CX. 2

Device C (2,3 3

Device D (2,4 4

Device A (3,1 5

Device B (3,2 6

Device C (3,3 7

Device D (3,4 8

Immediate Data Collection I

Configure C

Manual Connection M

Unit Reset R

Module Status S

Logout T

Enter Request :

The names in the left column are the same as programmed for the Serial I/O Port Device

Names and the (m,n) numbers in the middle correspond to the module and port. Type

the number corresponding to the desired V72 module to select that port followed by

<ENTER>. Type "C" to receive the "Configuration" selection menu , "X" to exit, or "T"

to logout.

Once a port is selected, you can select another port by sending the Attention character

five times followed by a one second delay to invoke the port selection menu. If you type

"T" to logout, the V72 will respond with the following:

< Your ‘TELNET’ connection has terminated>

NOTE: The “CX” in the above menu selection indicates that Device B

(Module 2, Port 2) has been selected by another session hosted by the V72.

Users will see the following message when the V72 Ethernet host module wants to

connect with a previously established port connection made by another host module on

the M-Series DAC unit.