Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE OPERATION
____________________________________________________________________________
110
gateway. The Subnet Mask consists of four bytes with each byte ranging from 0 to 255
decimal. This parameter must be programmed before the V72 can be accessed on the
network. The factory default Subnet Mask is 0.0.0.0.
GATEWAY
The Gateway is the address of a router for connection to other networks. The Gateway
address consists of four bytes with each byte ranging from 0 to 255 decimal. The
factory default Gateway address is 0.0.0.0.
SELECT CODE
The Port Select Code is sent as part of a select sequence by the host terminal to the V72
in order to select specific modules or the main board of the M-Series unit and issue
configuration or data commands. The port select code is a programmable ASCII
character string that can range from 1 to 8 characters. The factory default port select
code is $BT.
PASSWORD
The V72 Password, if enabled, is required of all users who attempt to access the V72.
The Password consists of an ASCII character string with a maximum length of 8
characters. The factory default Password is BTA.
USER INTERFACE
The user interface is a collection of items that affect the presentation or formatting of
data and messages. These items are:
1) "ID Msg"----Module ID Message. This is the message which is sent
when the user first connects to the module. It identifies the V72 host
and the firmware revision number. This message may be prevented
from being displayed by disabling this option. Default is
"enabled".
2) "Login"----Login Procedure. The V72 implements an
authentication procedure, requiring the user to successfully submit a
password before gaining access to the module. Disabling this option
eliminates the need for users to log in, granting access upon
connection. Default is "enabled".
3) "IMR"----Immediate Mode Message Quick Release. This option
affects immediate mode messages only. In order to optimize data