Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
101
Enter Port Device Name (Max. 16 characters):
or ENTER for no change ...........:
Enter the desired Port Device Name up to 16 characters. For example, if you type
"PORT 4" followed by <cr>, the module will respond with:
Module 1 Serial Port Configuration :
Xon / XoffPort Device Name Baud
Rate
Word
Size
Stop
Bits
Parity
Xmit Recv
1 PORT 4 9600 8 1 None Off Off
Enter Port Device Name (Max. 16 characters):
or ENTER for no change ...........:
If the Port Device Name is satisfactory, type <cr>. The V93A will return to the main
configuration menu.
NOTE: If the V93A Connect Port ID Echo feature is programmed for Use
Device Name, the message sent to the host device when the host selects a
V74/V75 peripheral port will be the Device Name shown in the menu above.
PORT SELECT CODE
Type “4” (in the configuration main menu) and <cr> to change the port select code.
The module will respond:
Port Select Code is $BT
Enter Port Select Code (Max. 8 characters):
or ENTER for no change:
Type the desired Port Select Code followed by <cr>. For example, if you type #PORT
followed by <cr>, the V93A will respond with:
Port Select Code is #PORT
Enter Port Select Code (Max. 8 characters):
or ENTER for no change:
If no additional change is desired, type "ENTER". The V93A will store the new Port
Select Code permanently into non-volatile memory and return to the main configuration
menu
.