Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE CONFIGURATION

____________________________________________________________________________

TIME TAG COMMAND

The Time Tag (TT) command is used to enable or disable time tagging. The Time

Tag command has the following format:

TTn

where n = 1 or 2. 1 = enable and 2 = disable.

V93A HOST MODULE CONFIGURATION

Configuration changes for the V93A Host Module are made through the service port

or the service modem. To access the configuration mode of the module, use the

procedures on page 44.

CONFIGURATION MAIN MENU

With $CONFIG input the V93A host module installed as Module X will respond with

an identification block and a menu of the available configuration options similar to

the following:

Status 1

Serial Port Configuration 2

Port Device Name 3

Port Select Code 4

Attention Character 5

Disconnect Timeguard 6

Local Modem Setup 8

Exit X

Enter Request :

STATUS

Type “1” (in the configuration main menu) and <cr> to display the module status. The

module will respond:

Installed Modules : 1,2

Port Select Code is $BT

Attention Character is ;

Disconnect Time Guard10:28 AM is Disabled