Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
96
NOTE: Only ASCII characters A-F and 0-9 are acceptable.
DYNAMIC CONFIGURATION
Type “5” (in the configuration main menu) and <cr> to enable or disable the dynamic
configuration capability. The module will respond:
DYNAMIC CONFIGURATION COMMANDS
Dynamic Configuration Commands DISABLED
Enable 1
Disable 2
Exit X
Enter Selection:
Dynamic configuration mode allows the V79 PDI-1 to be programmed by
downloading dynamic (on-the-fly) commands.
EXIT
Type “X” (in the relay operating setup menu) and <cr> to exit the configuration
mode. The module will respond:
Save Changes as Defaults? (Y/N)
If you reply (Y), the settings are saved as the permanent power-up defaults. That is, if
the M16/M8 loses power for any reason, the settings saved as defaults become the
power-up settings. If you reply (N), your selections are saved as current (temporary)
operating settings, but are lost upon power-down. The most recent menu selections,
saved as defaults, are restored as the current operating parameters when power is re-
applied. If you reply (Y), the V79 PDI-1 will respond with:
Saving Configuration as Defaults...
Configuration complete
DYNAMIC CONFIGURATION PROCEDURE AND COMMANDS
V79 PDI-1 dynamic configuration commands are issued through a host module, the
service port, or the service modem (config ports). The V79 PDI-1 will recognize
dynamic configuration commands only when dynamic configuration is enabled. Use
the following procedure to send dynamic configuration commands to the V79 PDI-1: