Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
92
SET LATCH POLARITY
Latch Polarity HI TO LO
Low to Hi Transitions only 1
Hi to Low Transitions only 2
Exit X
Enter Selection:
Enter the desired Latch Polarity. The Latch Polarity is used to latch initial events for
individual inputs based on a positive going (LO to HI) or negative going (HI to LO)
input.
REPORTING SETUP
Type “3” (in the configuration menu) and <cr> to display the reporting setup menu.
The module will respond:
REPORTING SETUP
Reporting Method 1
Report Start Time 2
Report Interval 3
Host Address 4
Time Tag 5
Terminating Character(s 6
Exit X
Enter Selection:
REPORTING METHOD
Type “1” (in the reporting setup menu) and <cr> to change the reporting method. The
module will respond:
SELECT REPORTING METHOD
Reporting Method COMMAND
Command 1
Immediate (When Event Occurs) 2
Schedule 3
Exit X
Enter Selection: