Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
91
Type “1” (in the configuration main menu) and <cr> to display module status. The
module will respond:
MODULE STATUS
Debounce Delay (Milliseconds 100
Latch Polarity LO to HI
Reporting Method COMMAND
Reporting Start Time 24:00
Reporting Period 24:00
Host Address 1:1,1
Data Format HEX
Time Tagging DISABLED
Terminating Character(s) 0D0A
Dynamic Configuration DISABLED
Press a key to continue or X to Exit.
SAMPLING SETUP
Type “2” (in the configuration main menu) and <cr> to display the sampling setup
menu. The module will respond:
SAMPLING SETUP
Debounce Delay 1
Latch Polarity 2
Exit X
Enter Selection:
You may program the Debounce Delay the Latch Polarity from this menu. The Exit
selection will return you to the configuration main menu. For example, if you type
"1" (Debounce Delay), the PDI will respond with the following:
SET DEBOUNCE DELAY
(0-65535 Milliseconds)
Debounce Delay 100
Exit X
Enter Value<CR>, or X to EXIT:
Type the desired debounce delay time followed by <cr>. The debounce delay is used
to guard against erroneous events. An event will not be valid unless the input channel
has remained at a changed state for the debounce duration.
If you type "2" from the "Sampling Setup" menu shown on the previous page (Latch
Polarity), the PDI will respond with the following: