Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE CONFIGURATION

____________________________________________________________________________

TTn

where n = 1 or 2 (1 = enable and 2 = disable).

V79 PDI-1 AND V80 PDI-2 MODULE CONFIGURATION

To access configuration mode of the V79 PDI-1 or V80 PDI-2 use the procedures on

page 44.

MAIN MENU CONFIGURATION

With $CONFIG input the V79 PDI-1 module installed as Module X will respond with

an identification block and a menu of the available configuration options similar to

the following:

NOTE: The only difference in the configuration main menu for the PDI-1

or PDI-2 modules is the second line in the header showing the module type.

All subsequent menus are the same for both modules. Thus, only the V79

PDI-1 will be discussed in the following sections. The configuration menus

shown in the following sections are depicted with factory default settings

and may vary slightly in presentation.

DAC V79 PDI-1 Rev. 1.XX

This Module is X

CONFIGURATION MAIN MENU

Module Status 1

Sampling Setup 2

Reporting Setup 3

Dynamic Configuration 4

Exit X

Enter Selection:

MODULE STATUS