Owner`s manual

9
RPC-2 MD01/RPC-2 RDR QUICK START
Using the RJ04X007 (RJ-11) modular cable,
connect either port labeled “LINE” on the
RPC unit to the telco wall jack. Using
another RJ04X007 (RJ-11) modular cable,
connect the remaining port labeled “LINE”
on the RPC unit to the port labeled “LINE”
on the external modem.
Using the 25MRJ45MD-8 adapter and the
RJ08X007 (8-pin crossed) cable, connect the
DB-25 female port of the modem to the
RJ-45 port labeled “EIA-232” on the back of
the RPC unit.
RPC-2 RDR EXTERNAL You must customize the external modem’s
COMMAND SUMMARY configuration to operate properly with the
RPC-2 RDR. See Appendix C, MODEM
COMMAND SUMMARY.
OPERATION
Accessing Main Menu Using a communications software, package,
Via Modem dial the modem. After a connection has
been established, the RPC sends the
following header:
RPC-2 Series
(C) 1997 by BayTech
F2.07
If you set a password when you were locally
connected to the RPC through the serial
port, the following header appears. Note
the additional prompt for a password: