Owner`s manual

RPC-2 MD01/RPC-2 RDR QUICK START

____________________________________________________________

RPC-2 Series

F2.07

Circuit Breaker : On

1) . . . OUTLET 1 : Off

2) . . . OUTLET 2 : Off

3) . . . OUTLET 3 : Off

4) . . . OUTLET 4 : Off

5) . . . OUTLET 5 : Off

6) . . . OUTLET 6 : Off

RPC >

If the status menu fails to appear, ensure

the correct cables and adapters are being

used and that they are connected properly.

Also, verify the serial communication

parameters are correctly configured.

Controlling Receptacles To set or change the status of the

receptacles, enter one of the following

commands: ON n, OFF n, REBOOT n,

where “n” is the outlet number you wish to

send the command. Entering an outlet

number of “0” sends the command to all

outlets.

CONFIGURATION Type “CONFIG” from the RPC-2> prompt.

The following menu appears:

RPC >CONFIG

1) . . . Change Password

2) . . . Change Outlet Name

Enter Request: