Owner`s manual

63
Enter the number of the session to terminate. The
RPC responds:
<Connection being terminated. Strike CR to continue. >
Outlet Status The following table shows the status of all outlets:
Outlet Status
Selection Outlet Outlet Power
Number Name Number Status
1 OUTLET 1 1 Off
2 OUTLET 2 2 Off
3 OUTLET 3 3 Off
4 OUTLET 4 4 Off
5 OUTLET 5 5 Off
6 OUTLET 6 6 Off
7 OUTLET 7 7 Off
8 OUTLET 8 8 Off
RPC-3 AND RPC-3A RESET UNIT
____________________________________________________________
5.3.7 RESET UNIT
Reset the unit to load new configuration changes. You must reset for
network parameters, such as IP Address, to take affect.
From the main menu, select #5, “Reset Unit.” The RPC responds:
Reset Unit? (Y/N)
Type “Y” for yes; allow approximately 5 seconds for unit reset.
5.3.8 COMMAND SUMMARY