Owner`s manual

49
command to REBOOT (n) is sent from the RPC > prompt, the RPC
powers “Off” corresponding outlet(s) for approximately 10 seconds plus
the programmed outlet delay time, then returns them to the state they were
(“On” or “Off”) prior to receiving the reboot command.
NOTE The reboot command will only reboot outlets that are
turned ON; an outlet that is turned OFF cannot be rebooted.
RPC-3 AND RPC-3A OPERATIONS
____________________________________________________________
5.3.4.2 Manage Users
Selection #2, “Manage Users,” from the main menu allows the admin user
to add and delete users, change passwords, and change the outlet list that
determines an outlet user’s access to prescribed outlets.
From the main menu, select #2, “Manage Users.” The following menu
appears:
User Management Menu
To modify existing user, enter number of user.
To add/delete user, select appropriate menu choice.
Enter request, CR to exit menus.
1) . . . Add user
2) . . . admin
If this is not an initial setup and optional outlet users have been added,
they too will show in the User Management Menu, along with the option
to delete users.
User Management Menu
To modify existing user, enter number of user.
To add/delete user, select appropriate menu choice.
Enter request, CR to exit menus.
1) . . . Add user