Owner`s manual

NOTE The outlet user sees only those outlets as assigned to him by

the admin user.

From the RPC > prompt, enter one of the following commands: ON n,

OFF n, REBOOT n, where “n” is the outlet number you wish to send the

command. Entering an outlet number of “0” sends the command to all

outlets.

RPC OWNER’S MANUAL

____________________________________________________________

Example: To turn “On” Outlet 3, type ON 3 from the RPC prompt

(RPC >). The RPC responds with:

Turn On Outlet 3 (Y/N)?

Responding “Y” for yes turns “On” Outlet 3. Observe the

status of Outlet 3 has changed to On in the status menu:

Circuit Breaker : On

Selection Outlet Outlet Power

Number Name Number Status

1 OUTLET 1 1 Off

2 OUTLET 2 2 Off

3 OUTLET 3 3 Off

4 OUTLET 4 4 Off

5 OUTLET 5 5 Off

6 OUTLET 6 6 Off

7 OUTLET 7 7 Off

8 OUTLET 8 8 Off

RPC >

Likewise, typing ON 0 at the RPC > prompt and responding “Y” for yes,

turns “On” all outlets. Typing OFF n at the RPC > prompt turns off

corresponding outlet(s).

The REBOOT n command will reboot or reset equipment attached to

corresponding receptacle(s), if the outlet is turned ON. When the