Owner`s manual

43
Example: To turn “On” Outlet 3, type ON 3 from the RPC prompt
(RPC >). The RPC responds:
Turn On Outlet 3 (Y/N)?
Responding “Y” for yes turns “On” Outlet 3. Observe the
status of Outlet 3 has changed to On in the status menu:
RPC-2 Series
(c) 1997 by BayTech
F2.07
Circuit Breaker : On
1) . . . OUTLET 1 : Off
2) . . . OUTLET 2 : Off
3) . . . OUTLET 3 : On
4) . . . OUTLET 4 : Off
5) . . . OUTLET 5 : Off
6) . . . OUTLET 6 : Off
RPC >
Likewise, typing ON 0 at the RPC > prompt and responding “Y” for yes,
turns “On” all outlets. Typing OFF n at the RPC > prompt turns off
corresponding outlet(s).
The REBOOT n command will reboot or reset equipment attached to
corresponding receptacle(s). When the command to REBOOT (n) is sent
from the RPC > prompt, the RPC powers “Off” corresponding outlet(s)
for approximately 10 seconds, then returns them to the state they were
(“On” or “Off”) prior to receiving the reboot command.
RPC OWNER’S MANUAL
____________________________________________________________