Owner`s manual

IMPORTANT You must customize the external modem’s configuration

to operate properly with the RPC-2 RDR. See Appendix C (MODEM

COMMAND SUMMARY) for information on customizing external

modem configurations.

5.2.2.2 REMOTE OPERATION

The RPC’s main menu allows you to monitor and control the equipment

attached to each of the RPC-2 RDR and RPC-2 MD01’s six receptacles.

From this menu, the user can turn on, turn off, or reboot attached

equipment, individually, or all equipment, simultaneously.

The RPC recognizes three basic operating commands: ON n<cr>, OFF

n<cr>, and REBOOT n<cr>, where n represents the outlet number and

<cr> represents a carriage return.

Accessing Main Menu via Modem Using a communications software,

dial the modem using the ATDT command. If the modem does not

respond in 5 to 7 rings, the RPC’s RDR feature recycles power to Outlet 6

and consequently resets the modem. Dial the modem again using the

ATDT command. When a connection has been established, the RPC

sends the following header:

RPC-2 Series

F2.07

If you set a password when you were locally connected to the RPC

through the serial port, the following header appears. Note the additional

prompt for a password:

RPC-2 Series

F2.07

Enter Password:

RPC OWNER’S MANUAL

____________________________________________________________