Owner`s manual

4
RPC OWNER’S MANUAL
____________________________________________________________
Also, verify the serial communication
parameters are correctly configured.
Controlling Receptacles
RPC-2/RPC-2A To set or change the status of the
receptacles, enter one of the following
commands: ON n, OFF n, REBOOT n,
where “n” is the outlet number you wish to
send the command. Entering an outlet
number of “0” sends the command to all
outlets.
CONFIGURATION Type “CONFIG” from the RPC>prompt.
The following menu appears:
RPC-2 RPC >CONFIG
1) . . . Change Password
2) . . . Change Outlet Name
Enter Request:
RPC-2A RPC > CONFIG
1) . . . Change Password
2) . . . Change Outlet Name
3) . . . Enable/Disable Confirmation
4) . . . Enable/Disable Status Menu
X) . . . Exit
Enter Request:
Programming a Password
RPC-2/RPC-2A Select #1, “Change Password,” press
<Enter.> NOTE The password is