Owner`s manual

Since the factory default password is a carriage return, hit <Enter.> If this

is not an initial set-up and a password has already been set, enter the

current password, followed by a carriage return. If you enter the password

incorrectly, the RPC responds with an “Error” message and returns to the

main menu. Consequently, you must start over by typing “CONFIG” to

access the configuration menu. If you enter the current password

correctly, the RPC responds:

Enter New Password:

Enter a new password (maximum field length, 8 alphanumeric characters),

followed by a carriage return. The RPC responds:

Re-Enter New Password:

Re-enter the new password identically to the first entry. Remember that

the password feature is case sensitive. If you fail to re-enter the new

password correctly, the RPC responds with an “Error” message and

returns to the main menu. Consequently, you must start over by typing

CONFIG” from the RPC > prompt to access the configuration menu. If

you re-enter the new password correctly, the RPC returns to the main

menu again, but you will not get an “Error” message.

Circuit Breaker : On

1) . . . OUTLET 1 : Off

2) . . . OUTLET 2 : Off

3) . . . OUTLET 3 : On

4) . . . OUTLET 4 : Off

5) . . . OUTLET 5 : Off

6) . . . OUTLET 6 : Off

RPC >

Disabling a Password To disable a password, enter a carriage return at

the “Enter New Password” prompt. Enter another carriage return at the

RPC-2 RDR/RPC-2 MD01 OPERATIONS & CONFIGURATION

____________________________________________________________