Owner`s manual

If the status menu fails to appear, ensure the correct cables and adapters

are being used and that they are connected properly. Also, verify the

serial communication parameters are correctly configured.

Controlling Receptacles To set or change the status of receptacles,

enter one of the following commands: ON n, OFF n, REBOOT n, where

“n” is the outlet number you wish to send the command. Entering an

outlet number of “0” sends the command to all outlets.

Example: To turn “On” Outlet 3, type ON 3 from the RPC prompt

(RPC >). The RPC responds:

Turn On Outlet 3 (Y/N)?

Responding “Y” for yes turns “On” Outlet 3. Observe that

the status of Outlet 3 has changed to On in the status menu:

RPC-2 Series

F2.07

Circuit Breaker : On

1) . . . OUTLET 1 : Off

2) . . . OUTLET 2 : Off

3) . . . OUTLET 3 : On

4) . . . OUTLET 4 : Off

5) . . . OUTLET 5 : Off

6) . . . OUTLET 6 : Off

RPC >

Likewise, typing ON 0 at the RPC > prompt and responding “Y” for yes,

turns “On” all outlets. Typing OFF n at the RPC > prompt turns off

corresponding outlet(s).

RPC-2 RDR/RPC-2 MD01 OPERATIONS & CONFIGURATION

____________________________________________________________