Owner`s manual

5.2.1.3 LOCAL OPERATION

The RPC’s main menu allows you to monitor and control equipment

attached to each of the RPC-2 RDR and RPC-2 MD01’s six receptacles.

From this menu, you can turn on, turn off, or reboot attached equipment,

individually, or all equipment, simultaneously.

The RPC recognizes three basic operating commands: ON n<cr>, OFF

n<cr>, and REBOOT n<cr>, where n represents the outlet number and

<cr> represents a carriage return.

There are six red LEDs on the front of the RPC unit. There is a

corresponding red LED for each of the RPC’s six receptacles. If any or all

of the LEDs are illuminated, corresponding receptacle(s) are turned "ON,"

and consequently, attached equipment is receiving power. If any or all of

the LED’s are not illuminated, corresponding receptacle(s) are turned

“OFF.”

Accessing Main Menu Power on the RPC unit. The following outlet

and circuit breaker status menu appears:

RPC-2 Series

F2.07

Circuit Breaker : On

1) . . . OUTLET 1 : Off

2) . . . OUTLET 2 : Off

3) . . . OUTLET 3 : Off

4) . . . OUTLET 4 : Off

5) . . . OUTLET 5 : Off

6) . . . OUTLET 6 : Off

RPC >

RPC OWNER’S MANUAL

____________________________________________________________