Owner`s manual

31
Enter a new password (maximum field length, 8 alphanumeric characters),
followed by a carriage return. The RPC responds:
Re-Enter New Password:
Re-enter the new password identically to the first entry. Remember that
the password feature is case sensitive. If you fail to re-enter the new
password correctly, the RPC responds with an “Error” message and
returns to the main menu. Consequently, must start over by typing
CONFIG” from the RPC > prompt to access the configuration menu. If
you re-enter the new password correctly, the RPC returns to the main
menu again, but you will not get an “Error” message.
Circuit Breaker : On
1) . . . OUTLET 1 : Off
2) . . . OUTLET 2 : Off
3) . . . OUTLET 3 : On
4) . . . OUTLET 4 : Off
5) . . . OUTLET 5 : Off
6) . . . OUTLET 6 : Off
RPC >
Disabling a Password To disable a password, enter a carriage return at
the “Enter New Password” prompt. Enter another carriage return at the
“Re-enter New Password” prompt. Changing the new password to a
carriage return disables password protection. See Programming a
Password above.
2. Change Outlet Name
RPC-2/RPC-2A
Select #2, “Change Outlet Name,” and press <Enter.> The RPC sends the
following menu:
1) . . . OUTLET 1
2) . . . OUTLET 2
3) . . . OUTLET 3
4) . . . OUTLET 4
5) . . . OUTLET 5
6) . . . OUTLET 6
Enter Request:
RPC OWNER’S MANUAL
____________________________________________________________