Owner`s manual

29
RPC-2 Series
(c) 1997 by BayTech
F2.07
Circuit Breaker : On
1) . . . OUTLET 1 : Off
2) . . . OUTLET 2 : Off
3) . . . OUTLET 3 : On
4) . . . OUTLET 4 : Off
5) . . . OUTLET 5 : Off
6) . . . OUTLET 6 : Off
RPC >
Likewise, typing ON 0 at the RPC > prompt and responding “Y” for yes,
turns “On” all outlets. Typing OFF n at the RPC > prompt turns off
corresponding outlet(s).
The REBOOT n command will reboot or reset equipment attached to
corresponding receptacle(s). When the command to REBOOT (n) is sent
from the RPC > prompt, the RPC powers “Off” corresponding outlet(s)
for approximately 10 seconds, then returns them to the state they were
(“On” or “Off”) prior to receiving the reboot command.
5.1.4 CONFIGURATION
The RPC-2’s configuration menu allows the user to (1) set or change a
password and (2) customize the outlet name(s) to identify equipment
attached to the RPC. In addition to “Change Password” and “Change
Outlet Name,” the RPC-2A’s configuration menu allows
enabling/disabling confirmation and enabling/disabling status menu.
The password is disabled from the factory by making the password a
carriage return. If a password (other than a carriage return) is set, the RPC
requires password entry before allowing the user to operate the RPC unit.
REMEMBER, the password feature is case sensitive.
RPC OWNER’S MANUAL
____________________________________________________________